Before Start-Up; Start-Up; Maintenance And Cleaning - Silvercrest IAN 322642_1901 Bedienungs- Und Sicherheitshinweise

F
Please take care to mount the wall brackets
as shown in the illustration (See Fig. F)
Now secure the lower two wall brackets
the supplied M4 x 30 mm Phillips screws
attaching the wall brackets
G
Now place the
the newly attached
(See Fig. G)
H
Now position the upper two wall brackets
the product and screw them to the wall as well.
Please take care to mount the wall brackets
as shown in the illustration. (See Fig. H)
Notice: Ensure that the M4 x 30 mm Phillips screws
for attaching the wall brackets are tightened and
9
that the electric towel rail cannot fall down. This could
lead to property damage and/or personal injury.
20 GB/IE/NI
2
with
2
for
9
.
2
electric towel rail
wall brackets
2
on
2
2

Before start-up


Before the first start-up, check that the mains volt-
age corresponds to the voltage indicated on the
device.
Please take care that the mains cable does not
become a tripping hazard. Always route the
power cable away from the rear of the unit.

Start-up


Insert the mains plug
socket.
Turn the electric towel warmer on by setting the
On/Off switch
indicates when the unit is switched on.
Never hang towels and clothing in an overlapping
manner to prevent the device from overheating.
After use, turn the unit off using the on/off switch
by setting the On/Off switch
3
The red control lamp will go out. Now pull the plug
out of the socket.

Maintenance and cleaning


in
.
CAUTION! DANGER OF ELEC-
TRIC SHOCK! Before cleaning, un-
plug the device from the wall outlet
and allow it to cool down completely.
The device should only be cleaned externally -
using a soft, slightly damp cloth. Do not use any
liquids or cleaning agents under any circum-
stances as they may damage the device.
into a suitably fused
4
to ON . The red control lamp
3
to OFF .
3