Direction Control; Torque Control; Gear Selection - Westfalia A2S18 Originalanleitung

Direction Control

WARNING: Never change the direction of rotation while the tool is
running. This may cause permanent damage to the tool.
 The direction of rotation can be set using the forward/reverse
switch (6).
1. For anti-clockwise rotation, push the switch to the right.
2. For clockwise rotation, push the switch to the left.
Note: When the forward/reverse switch is in the central position, the
tool is locked and cannot be switched on. Use this setting as a safety
feature to prevent the tool from being switched on accidentally.

Torque Control

The drill is equipped with a torque control clutch allowing the machine
to be set to the correct torque for the individual application.
The higher the number displayed on the torque selector (3), the higher
the torque produced by the tool.
If in doubt which torque setting best suits the application, start with a
low setting and increase, should more torque be required (e.g. if the
screw is not being driven far enough into the workpiece).

Gear Selection

The cordless drill is equipped with 2 gears. The gear
switch is located on top of the cordless drill.
st
L = low = 1 gear
The revolution in the 1
When L is visible, the 1
nd
H = high = 2
The revolution in the 2
When H is visible, the 2
Do not change the gear while the motor is running! This will lead to
damage to the machine.
 Select low gear L on the gear switch (4) for the higher torque. A
lower speed gear is generally more suitable for driving screws and
st
gear is 0 – 400 min
st
gear is selected.
gear 0 – 1500 min
nd
gear is 0 – 1500 min
nd
gear is selected.
Operation
-1
-1
.
24
.
-1
.