Service; General Inspection - Westfalia A2S18 Originalanleitung

 Make sure that drill bits are suitable for wood, metal or plastics and
are within the maximum capacity of this machine (see 'Technical
Data').
WARNING: Do not inhale wood dust. Wear adequate breathing
protection. Some wood dusts may be toxic.
 To ensure accuracy, mark the intended hole position using a
hammer and centre punch.
WARNING: The drill bit and the workpiece will become very hot
when drilling metal. Do not touch the bit and never allow it to come
into contact with combustible materials when hot. Always use a
suitable lubricant or cutting fluid, and drill at appropriate speeds.
 Only apply moderate pressure to the drill bit, ensuring efficient
cutting and prolonged drill bit life.
 Use a countersink bit to remove sharp burrs from the hole to prevent
cuts and other kinds of injury.
WARNING: If the power tool gets excessively hot in use, stop using the
tool immediately and allow cooling before continuing work. The cooling
period can be reduced by operating the tool at maximum speed with no
load. Always make sure the motor vents (5) are not blocked and do not
allow dust to enter the body of the tool through the motor vents; dust,
especially metallic dust, may damage or destroy the tool.

Service

WARNING: Always disconnect from the mains power supply, before
carrying out any maintenance/cleaning of the charger. Remove the
battery before carrying out any maintenance/cleaning of the tool.
Note: Both the tool and the charger contain no user-serviceable parts. If
the device does not perform as outlined in this manual, turn to the
Westfalia customer service or to a competent professional.

General Inspection

 Regularly check that all the fixing screws are tight as they may
become loosened during use due to vibration.
 Inspect the supply cord of the charger for damage or wear prior to
each use. Repairs should be carried out by an authorised service
Operation
26