Cable Antenna; Initial Start-Up; Display Lighting; Switching The Device On And Off - Silvercrest SURF 600 A1 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SURF 600 A1

Cable antenna

There is a cable antenna on the back of the device (10). This is rolled up in the package contents when
delivered. Unwind it to improve the reception quality of the radio and radio clock.

Initial start-up

Display lighting

The brightness of the display can be adjusted to one of four levels, depending on your requirements. To
do this, in off mode, press the multi-function controller (1) until you reach the required brightness for the
display. Generally, each time you press a button or turn the multi-function controller (1), the display
lighting is set to the maximum brightness for approx. ten seconds.
Regardless of your preferred brightness setting, an automatic dimming function sets the brightness of the
display at the lowest level from 11 pm to 6 am. This duration can not be changed. If you manually
change the brightness of the display during this time, the dimming function will switch off until 11 pm the
next evening. Only then will the dimming function be reactivated and set the brightness of the display at
the lowest level.
You can activate or deactivate the automatic dimming function as necessary for the time between 11 pm
and 6 am. Proceed as follows:

In off mode, press and hold the "SET/MEMORY" button (7) for approx. two seconds until the display
indicator changes from the current time to "rcc".

Briefly press the "SET/MEMORY" button (7) six times.

By turning the multi-function controller (1), select "AS0" to deactivate the dimming function and "AS1"
to activate it.

Confirm your choice by pressing the multi-function controller (1) or the "SET/MEMORY" button (7).

Switching the device on and off

To switch on the device, briefly press the "ON/OFF" button (5) once. In active mode, the display (11)
shows the set frequency for approx. 10 seconds before automatically changing to the time. You can show
the frequency again on the display (11) by pressing the "Display" button (3). When a Sleep-Timer is
activated only the remaining time of the Sleep-Timer is indicated after pressing the button "Display" (3).
To switch off the device, press the "ON/OFF" button (5) again. In off mode, the display (11) shows the
current time. The day and month can be shown on the display (11) by pressing the "Display" button (3)
and pressing again will display the year. After approx. five seconds, the display returns to the current time.
34 - English