Before First Use; Assembling; Operating - Westfalia YLQ20S-100 Bedienungsanleitung

Before first Use

Remove the unit and the accessory out of the packaging. Keep packaging
materials out of reach of children. There is risk of suffocation!
Clean all parts of the unit before using for the first time, as described in the
chapter "Cleaning" on page 14.
According to factory-made functional tests, residual humidity can remain in the
pump. Residual humidity in a new article in not a fault.
According to BS EN 1717 it is not permitted to connect a high-pressure
cleaner directly to mains drinking water supply. Short-term connection is
permissible, if a backflow preventer valve is installed in the supply hose.
Respect the requirements of the local water supply company when using high-
pressure cleaners.
The high-pressure cleaner is provided with overheating protection. This
overheating protection protects the motor against overheating and damaging.
If the thermal sensor is activates wait some minutes. Wait until the thermal
sensor has cooled down and switch on the cleaner again.

Assembling

1. Place the high-pressure cleaner on a solid,
level ground. Do not operate the high-
pressure cleaner tilted bun only in upright
position.
2. Insert the filter (3) into the water inlet
connector (4) and screw the water inlet
connector with pliers using less pressure on
the coupling for the water inlet connector (2).
The inlet filter must always be fitted in
the water inlet hose to filter out sand,
limestone and other impurities as
these will damage the pump.
3. Connect the water hose with the
coupling and water supply.

Operating

11