Inflating With The Low Pressure Hose; Deflating With The Low Pressure Hose - Westfalia ALK 18 Originalanleitung

 Remove the adaptor by lifting the air chuck clamp up and pulling the
adaptor (or needle) from the air chuck.

Inflating with the low Pressure Hose

The low pressure hose ls used to inflate low pressure items, such as air
mattresses, pools, and floats.
Note: A pinch valve adaptor (7) comes as part of the inflating nozzle
assembly that is attached to the end of the low pressure hose. The
pinch valve adaptor is used for items that have a smaller air opening or
pinch valve. Insert pinch valve adaptor into pinch valve, insuring that
the tip of the adaptor is inserted past the inner "flap" inside the valve.
When inflating, ensure that the tip is not blocked during inflation.
 To attach the low pressure hose, align the slots in the hose with the
pins on the sides of the inflation flange (5).
 Turn the hose clockwise as far as it will turn.
 Use the suitable adaptor to connect the hose to the item to be
inflated.
 Set the main switch (3) to low pressure (I) to start inflating.
 When the desired pressure is reached set the main switch to O and
close the valve of the item inflated.
 Remove the hose by turning it counter clockwise as far as it will turn
and removing it from the inflation flange.
 Store the hose in hose wrap on the left side of the compressor.
Note: Always leave low pressure hose free of obstructions and with
pinch valve adaptor off when not in use. Overheating could occur if the
low pressure hose ls blocked.

Deflating with the low Pressure Hose

The low pressure hose, when placed ln the deflation flange (6), can be
used to remove air from inflated items.
 Place the hose inside the deflation flange (6).
 Set the main switch to low pressure (I) to start deflating.
 When the item has been deflated, turn the main switch to O.
 Remove the hose by pulling if from the deflation flange.
 Store the hose in hose wrap on the left side of the compressor.
Operation
27