Intended Use; Unpacking The Compressor; Before Use; Inserting And Removing The Battery - Westfalia ALK 18 Originalanleitung

Intended Use

The compressor is intended for filling bicycle and motor vehicle tyres
and for inflating toys, floats, balls and the likes. Additionally the
compressor can be used to deflate toys, floats, inflatable pools and the
likes.
The compressor is not intended for filling lorry or tractor tyres. It is
intended for domestic used and not continuous commercial operation.

Unpacking the Compressor

 Carefully unpack and inspect your compressor. Familiarise yourself
with all its features and functions.
 Ensure that all parts of the tool are present and in good condition. If
any parts are missing or damaged, have such parts replaced before
attempting to use the compressor.

Before Use

Please note that that battery and charger are not included with the tool!

Inserting and Removing the Battery

1. To fit a charged battery, slide it on to the hand grip of the cordless
drill until it clicks and locks into position.
2. To remove the battery (10) from the tool, press the battery release
button, then slide the battery off the hand grip.
WARNING: Do not try to remove the battery without pressing the
battery release button. The cordless drill or battery could be damaged.
Note: Make sure the battery and cordless drill are lined up correctly. If
the battery does not slide into the tool easily, do not force it. Instead,
slide the battery out of the tool again, check the top of battery and the
cordless drill battery slot are clean and undamaged and that the
contacts are not bent.
Setting up the Battery Charger – (Battery and Charger not included)
1. If fitted, remove the battery from the battery charger.
2. Insert the battery charger mains plug into a suitable mains socket.
Note: One LED on the charger will indicate ready status. For further
information please refer to the included manual of the included charger.
Operation
22