Accessories; Spare Parts - Kärcher WPD 50 Bedienungsanleitung

Emptying the drip pan
The float signals that the drip pan is full. A red marking
ring becomes visible when the maximum filling level has
been reached.
 Set the appliance switch to "0".
 Remove the drip pan.
 Empty the drip pan.
 Check drip pan for soiling and clean as necessary.
 Insert drip pan.
 Set the appliance switch to "I".
The device is ready for operation again.
Maintenance of the UV-C emitter
Safety instructions for UV-emitter
WARNING
– This appliance contains a UV-C emitter.
– Unintended use of the appliance or damaging the
housing may result in the escape of dangerous UV-
C radiation. UV-C radiation may, even in little dos-
es, cause to harm the eyes and skin.
– Appliances that are obviously damaged must not
be operated.
– Read the maintenance instructions before opening
the appliance.
– Disconnect the appliance from power supply be-
fore opening and replacing the UV-C emitter.
WARNING
Do not operate the UV-C emitter when it is removed
from the appliance enclosure.
Uninstalling and installing the UV-lamp
The lamp of the UV filter must be replaced every six
months.
Note
Opening the lateral appliance cover actuates the safety
button and the lamp of the UV filter is switched off for
safety purposes.
 Set the appliance switch to "0".
 Disconnect the mains plug from the socket.
 Open the lock.
 Remove the lateral appliance cover.
1 Connection cable
2 Cover cap
3 Water output
4 UV filter
5 Water inlet
6 UV filter safety button
 Pull the UV filter from the support.
12
1 Top connector
2 Illuminant
3 Lock nut with seal
4 UV filter casing
5 Cover cap
CAUTION
Risk of burns from hot lamp! Allow the lamp to cool
down prior before removing it.
Note
Do not unscrew the lock nut with seal (water leak).
 Remove the cover cap, avoiding rotational move-
ment.
 Pull the lamp approx. 10 cm out of the cylinder.
 Remove upper plug.
 Pull the lamp out of the cylinder.
 Remove lower plug.
 Remove lamp and dispose of in accordance with
local regulations.
ATTENTION
Lamps are sensitive to grease. To not touch lamps with
bare fingers. Prior to installation, clean soiled lamps by
means of a dry, grease-free cloth.
 Remove new lamp from the packaging.
 Attach lower plug to the new lamp.
 Insert the lamp into the UV filter.
Note
Carefully slide the two cables of the lower plug into the
UV filter simultaneously with the lamp.
 Attach upper plug to the lamp.
 Fit cover.
 Plug the UV filter into the holder.
 Reinsert and lock the lateral appliance cover.
 Insert the mains plug into the socket.
 Set the appliance switch to "I".
Warranty
The warranty terms published by the relevant sales
company are applicable in each country. We will repair
potential failures of your appliance within the warranty
period free of charge, provided that such failure is
caused by faulty material or defects in manufacturing. In
the event of a warranty claim please contact your dealer
or the nearest authorized Customer Service centre.
Please submit the proof of purchase.

Spare parts

 Only use original accessories and spare parts, they
ensure the safe and trouble-free operation of the
device.
 For information about accessories and spare parts,
please visit www.kaercher.com.
4
-
EN

Accessories

Rinse cup
Description
Rinsing cup 4 l
Botlles
Description
Bottle 0.5 l, made of Tri-
tan, dishwasher-safe
Bottle 0.75 l, made of Tri-
tan, dishwasher-safe
Bottle 0.6 l with mouth-
piece and lid made of Tri-
tan, dishwasher-safe
Cup
Description
Plastic cup, 200 ml, without logo,
3,000 pieces
Plastic cup, 200 ml, with KÄRCHER
logo, 3,000 pieces
Hard paper cup, also for hot bever-
ages, 180 ml, without logo, 2,500
pieces
Hard paper cup, also for hot bever-
ages, 180 ml, with KÄRCHER logo,
2,500 pieces
Pitchers
Description
Water pitcher, 1 l, glass,
with plastic lid and
KÄRCHER logo, dish-
washer-safe
Installation material
Description
Fault current protective switch 30
mA, 230 V, 50 Hz
Aquastop, leakage water indicator
with solenoid valve and brass screw
connection G 3/4"
Pressure reducer 1.5 - 6 bar - ½
Water block, flooding fuse
Check-valve
Order No.
6.640-341.0
Order No.
6.640-430.0
6.640-512.0
6.640-469.0
Order No.
6.640-454.0
6.640-453.0
6.640-455.0
6.640-460.0
Order No.
6.640-431.0
Order No.
6.640-427.0
6.640-291.0
6.640-625.0
6.640-338.0
4.640-463.0