Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Changing the Reel
The protective cover must be
fully mounted when using
the thread spool. (See Chap-
ter: "Removing/mounting the
protective cover extension")
1. Switch off the engine.
2. Place the equipment on the
ground and ensure that no fuel
leaks and that the equipment is
safely supported.
3. Block the uptake spindle (51)
using the Allen key (25) as de-
picted. Use the larger of the two
Allen keys (5 mm).
Screw the spool case (15) clock-
wise to the mounting spindle (51).
4. Open the spool case (15) by
firmly pressing the click lock in-
wards (41) on both sides of the
spool case (15), and remove the
spool case cover.
A Phillips-head screwdriver can
be used to assist in opening the
spool case.
Proceed with caution: do not
damage the spool.
5. Place the new spool (16) into
the spool case cover (15) and
insert the two ends of the thread
through the thread outlets (42).
6. Place the thread spool (16) into
the spool case cover (15) and al-
low the cover to latch back into
the spool case (15).
Ensure that the thread outlets
(42) match the two recesses (43)
in the spool case otherwise the
cover will not close.
7. Screw the spool case (15)
counter-clockwise back onto
the mounting spindle (51). Re-
move the hexagon socket
wrench (25).
8. Pull on both ends of the thread to re-
lease the threads from the grooves.
9. Trim the thread line to approx.
15 cm to release strain on the
engine when starting and warm-
ing up.
The spare parts which are to be
ordered can be found in the "Spare
parts/accessories" section
Changing blades
Risk of injury! Caution - sharp
edges! Wear gloves.
The protective cover must be
shortened when using the
blade. (See Chapter: "Re-
moving/mounting the protec-
tive cover extension")
1. Switch the engine off.
2. Place the device on the ground in a stable
position and ensure that no fuel escapes.
3. Block the uptake spindle (51) using the
Allen key (25) as depicted. Use the
larger of the two Allen keys (5 mm).
Turn the nut in a clockwise direction
to loosen it. Remove the nut, clamping
disk, washer and blade from the up-
take spindle.
4. Place either the 3-toothed (29) or
4-toothed blade (30) onto the mounting
spindle (51). The blade can be used on
both sides.
5. Fasten the blade using the washer (52),
conical spring washer (53) and nut (54).
6. Remove the hexagon socket
wrench (25).
GB
MT
47
Werbung
