Endress+Hauser ASP Inline Betriebsanleitung Seite 47

ASP Inline
!
Electrical connection (circuit
diagram)
Supply voltage
Cable entry
Cable specifications
Power consumption
Pneumatic connection
Ambient temperature range
Endress+Hauser
For a return, e.g. in case of repair, the device must be sent in protective packaging. The original
packaging offers the best protection for this. Repairs must only be carried out by your supplier's
service organisation.
Note!
Please enclose a note describing the fault and the application when sending the assembly in for
repair.
9.6 Disposal
The device contains electronic components and must, therefore, be disposed of as electronic waste
in the event of disposal. Please observe in particular the local waste disposal regulations of your
country.
10 Technical data
10.0.1 Inputs
1 control input
Valve "rinse water" (optional)
Valve "compressed air" (optional)
10.0.2 Outputs
1 signal output "cylinder up"
1 signal output "cylinder down"
10.0.3 Power supply
For circuit diagrams, see chapter 4, 'Wiring'
24 VDC
1 cable gland, M16 x 1.5
6 x AWG 24
UL-Style 2464 / 1061 (weather-proof, UV-resistant)
max. 1.8 W
The ASP Inline sampler assembly can either be driven pneumatically or by an electric motor
(optional).
See also chapter 3.3.3, 'Pneumatic connection'
10.0.4 Operating conditions
The operating conditions for the assembly can be found in chapter 3.2, 'Installation conditions'.
10.0.5 Environment
0 to +40 °C
Technical data
47