Hama GS536 Bedienungsanleitung Seite 12

7.4 Dismantling the smoke detector
• Turn the smoke detector counterclockwise to
remove it from the base plate.
• Remove the battery by disconnecting it from the
battery connection
• Store the smoke detector in a safe and dust-free
place if it is to be dismantled for a short time,
e.g. during renovation work, or replace it with
a new device
• Now carry out the assembly and function check
- as described in 5.2. Installing the smoke
detector.
8. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
9. Declaration of performance
The declaration of performance for this product can
be found at:
www.hama.com ->00223841 -> Downloads
10.Manufacturer and approval holder
Siterwell Electronics CO., Limited
No. 666 Qingfeng Road, Jiangbei District, Ningbo,
Zhejiang Province, China
Distributed by
Hama GmbH & Co KG
86652 Monheim / Germany
www.hama.com
17
1772
DoP: GS536G-DoP-002
EN14605:2005 + AC:2008
12
11.Technical data
Battery type
Current
consumption
Alarm volume
Detection method
Sound pattern of
the alarm
Temperature range
12. LED and acoustic signalling
LED flashes every
40 seconds
LED flashes quickly
(>1 x per second)
and the alarm
sounds
LED flashes every
40 seconds and a
short alarm tone
sounds
3V (CR123A) lithium
battery
(permanently
installed)
<10µA (Standby)
< 30mA (Alarm)
85dB(A) within 3
metres
Optical
3 x signal tone,
brief pause,
3 x signal tone,
brief pause,
3 x signal tone,
the LED flashes
quickly (> 1x per
second). Repeat of
the alarm pattern
5°C - 40°C
The smoke detector is
working properly
The TEST button was
pressed or the alarm
has been triggered
by smoke
The battery is
weak and must be
replaced