Parkside PLSA 40-Li C2 Originalbetriebsanleitung Seite 31

low as possible. Examples of measures to
reduce vibration exposure are the wearing
of gloves when using the tool and limiting
the working hours. For this purpose all parts
of the operating cycle have to be consid-
ered (for example, times when the electric
tool is switched off and times when it is
switched on but running without any load).
Charging time
The device is part of the (Parkside) X 20 V
TEAM series and can be operated with
batteries of the (Parkside) X 20 V TEAM
series.
Charging time (min.)
PLG 20 A1
PLG 20 A4
PLG 20 C1
PLG 20 A2
PLG 20 A3
PLG 20 C3
PDSLG 20 A1
PDSLG 20 B1
PLG 201 A1
Smart PLGS 2012 A1
The charging time is influenced by factors such as the temperature of the
environment and the battery, as well as the mains voltage applied, and may
therefore deviate from the specified values.
Safety instructions
This section describes the basic
safety rules when working with the
device.
PAP 20 A1
PAP 20 A2
PAP 20 B1 Smart PAPS 204 A1
60
45
135
35
Batteries of the (Parkside) X 20 V TEAM
series may only be charged using chargers
of the (Parkside) X 20 V TEAM series.
We recommend that you operate this
appliance with the following batteries only:
PAP 20 A1, PAP 20 A2, PAP
20 A3, PAP 20 B1, PAP 20 B3,
Smart PAPS 204 A1, Smart PAPS 208 A1
We recommend charging these batteries
with the following chargers:
PLG 20 A1, PLG 20 A2, PLG 20 A3,
PLG 20 A4, PLG 20 C1, PLG 20 C2,
PLG 20 C3, PDSLG 20 A1, PDSLG 20 B1,
Smart PLGS 2012 A1
PAP 20 A3
PAP 20 B3
120
60
250
45
Symbols and icons
Symbols on the appliance:
Warning!
Read the manual.
GB MT
Smart PAPS 208 A1
240
150
500
50
31