Setting The Current Time; Technical Data; Warranty Disclaimer - Hama Curved Bedienungsanleitung

4.1 Programming switch-on / switch-off times
To program the switch-on times, the grey tab is pushed
downwards according to the desired time.
1 tab equals 15 minutes. If a longer time span is
required, more tabs (15-minute intervals) must be
pushed downwards. Switch-off times: Tab position
> top

4.2 Setting the current time

The time selector dial is turned clockwise until the
arrow on the inner ring of the selector dial shows the
current time.
4.3 Connecting the timer to the mains,
connecting electrical appliances to the timer
Insert the plug of the timer into a 230 V protective
contact socket, then the mains plug of the electrical
appliance to be switched.
4.4 Manual switch on
The on switch on the right side of the timer allows the
user to switch the unit on permanently. If the switch
is set to the "I" position, the timer is permanently
switched on. (Tab setting "Off" is ignored), whereby
the clock continues to run. As soon as the switch is
returned to the "OFF" position (), the normal program
continues to run.
5. Care and maintenance
Note
Disconnect the device from the mains before
cleaning and during prolonged periods of non-use.
• Only clean this product using a lint-free, slightly
damp cloth and do not use any harsh cleaners.

6. Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or
from failure to observe the operating instructions and/
or safety notes.

7. Technical data

Mains connection
Connected load
Protection class
Protection
Switching intervals
Timer switch
230 V ~ / 16 (2) A
max. 3680 W
1
IP20
15-minute cycle
3