Installing The Heater; Filling Fuel - Zibro Kamin R 616 C Gebrauchsanweisung

B MANUAL
A

INSTALLING THE HEATER

1 Carefully remove your heater from the box and check the contents.
In addition to the heater you also need to have:
C
a manual fuel pump
a transportation cap
a fuel cap cover
these directions for use
Keep the box and the packaging materials (Fig. A) for storage and/or
transportation.
D
2 Remove the other packaging materials:
Remove the packaging material from the grill ¶. Lift the grill from the slot
(Fig. B) and pull it forward.
Push the packing material on top of the combustion chamber ¿ slightly
down and remove it (Fig. C). Remove the packaging materials from under
the combustion chamber as well (Fig. D).
E
Put the combustion chamber back into its place. The combustion chamber
is positioned correctly when it can be smoothly moved a little to the left
and to the right by its handle ´ (Fig. E). Close the grill: Slightly lift it to
reposition it in its slot.
Open the lid of the removable tank º and remove the piece of cardboard.
F
3 Fill the removable tank as indicated in Section B.
4 Insert the batteries into their holder
Ensure that the positive and negative poles match the + and - marks indicated
on the battery housing.
5
The floor should be firm and completely level. Reposition the heater, when it is
not level. Do not correct the situation by placing books or other goods under the
heater. Please refer to the separate instructions in the carton box for fixing of
the heater.
6 Your heater is now ready for use.
G
B

FILLING FUEL

Do not fill the removable tank in the living room, but in a more suitable place
(there can always be some spillage). Follow the procedure below:
H
1 Make sure that the heater is switched off.
Open the lid º and lift the removable tank ¾ out of the heater (Fig. G).
2
Note: Some drops may leak from the tank. Put down the removable tank
(cap pointing upwards) and screw off the fuel cap using the fuel cap cover
(Fig. H).
at the back of the heater (Fig. F).
4
53