Whispbar K944W Montageanleitung Seite 5

EN
Fitting Kit
K944W
Fitment
Position one end of crossbar on the
opposite roof rail and swing the free end so
that the clamp is under the rail and the
rubber gasket sits on top.
Repeat on other crossbar.
Crossbars should be parallel to each other
and sit perpendicular to the roof rails.
Pull legs out evenly until both rubber
gasket seal on roof rail.
Ensure each end of the crossbar is
adjusted equally.
Note that legs can pivot slightly to
accommodate for roof rail taper.
Once crossbars are in position, tighten
screw to 5 Nm (3.7 ft lb).
Repeat for all legs.
5