Switching Window; Programming Enable - HYDAC HDA 5500 Serie Benutzerhandbuch

HDA 5500
mode
Press mode key

11.2 Switching window

Procedure for HDA 5500 with two or four switching outputs (with switching output set to
switching window):
•
During normal operation, press the mode key. Win (switching window) appears.
Note: If mode is held down longer approximately 5 s, then the menu for basic settings is
activated!
•
As soon as mode is released, Hi.1 (upper switch point 1) is displayed.
• After approximately 2 s the display changes and the pre-set switch point is shown flash-
ing.
•
If mode is pressed again, Lo.1 (lower switch point 1) is shown.
•
By pressing mode once more on the HDA 5500 with two switching outputs, Hi.2 (upper
switch point 2) and Lo.2 (lower switch point 2) are shown one after the other; on the HDA
5500 with four switching outputs Hi.3 (upper switch point 3), Lo.3 (lower switch point 3),
Hi.4 (upper switch point 4) and Lo.4 (lower switch point 4) are also shown.
•
If an upper switch point or a lower switch point is shown flashing, the setting can be
changed by pressing
•
If or are not pressed for longer than approximately 3 s, then the display returns to
normal operation. Any altered settings are saved at the same time.
mode
Press mode key
Note:
•
Hold down or
•
If when pressing
is disabled. To enable programming, see chapter 12 Programming enable.

12 Programming enable

The unit has two types of programming enable, the operating programming enable and the
main programming enable. Both types must be enabled to change the settings.
The operating programming enable provides protection from unintentional changes to the
settings during normal operation. The operating programming enable can be altered during
operation.
The main programming enable provides general protection from changes to the settings.
The main programming enable can only be altered when the HDA 5500 is switched on.
All manuals and user guides at all-guides.com
Release mode key
or within approximately 3 s.
Release mode key
to scroll quickly through the values in the display.
or then Loc appears in the display this shows that programming
User Manual
mode
or
Use the
to change the setting
mode
Use the or
to change the setting
- 17 -