Use Descriptions; Cleaning And Maintenance; Troubleshooting - Free Village HZB-12/B Bedienungsanleitung

3. Use Descriptions

 Open the cover, remove the ice basket and pour water into the tank.
 Keep the water level below the max water line.
 Press the ON/OFF button on the control panel to begin the ice-making cycle.
 Select the ice cube size by pressing the SELECT button. If the room temperature is lower
than 15 °C, it is recommended to select the small ice cube to avoid ice sticking together.
 The ice-making cycle lasts approx. 6 to 13 minutes, depending on the selection of ice cube
size and the room temperature. The recommended room temperature is 10 °C - 40 °C.
 If the water pump cannot inject water, the ice maker will stop automatically, and the ADD
WATER indicator will be on. Press the ON/OFF button, and fill water up to the max. water
line. Press the ON/OFF button again to turn on the appliance again. Allow the refrigerant
liquid inside the compressor at least 3 minutes to settle before restarting.
 The ice maker stops when the ice basket is full and the ICE-FULL indicator will be on.
Warning: Direct sunlight or sunlight reflection may cause the infrared sensor malfunction. If the
appliance doesn't stop making ice when ice cubes obstruct the sensor, move the appliance to other
places where there is no sunlight.
 Change water in the water tank every 24 hours to ensure reasonable hygiene. If the appliance
will not be used for a long time, drain all the water and dry out the tank.

Cleaning and Maintenance

Before using the ice maker, it is strongly recommended to clean it thoroughly.
1. Take out the ice basket.
2. Clean the interior parts with diluted detergent, warm water and a soft cloth.
3. Rinse the interior parts with water, and drain out the water by unplugging the water drain cap
at the front bottom side.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution and
warm water.
5. Dry the interior and exterior parts with a clean soft cloth.
6. If the appliance will not be used for a long time, drain the water inside completely and dry it
out.

Troubleshooting

Problems
The ADD WATER
indicator is on.
The ICE-FULL
indicator is on.
Possible Causes
Lack of Water.
The ice is full in the ice
basket.
Solutions
Stop the ice maker, fill it with potable water,
and press the ON/OFF button to restart the
appliance.
Remove the ice from the ice basket.
Continuously press the SELECT button for 5s,
and the appliance will make ice 10 cycles even
though the ICE-FULL indicator is on.
5