Unpacking The Ice Maker - Free Village HZB-12/B Bedienungsanleitung

 Read and follow the operation instructions carefully.
 The appliance should be repaired only by trained service personnel. Do not puncture the
refrigerant tube.
 Contact us before attempting to install or service this appliance. All safety precautions must
be followed strictly.

Dispose of the appliance in accordance with federal or local regulations.
22. The appliance should be installed in accordance with the safety standard for refrigeration
systems, ASHRAE15. It should not be installed in corridors or hallways of public buildings.
23. If the appliance is of faults that need to be maintained, such as replacing its components, it
should be done by the factory-authorized service personnel, so as to minimize the risk of
possible ignition due to incorrect components or improper service.
24. The wires in this mains lead are colored in accordance with the following code:
Green or Green with a strip yellow:

Unpacking the Ice Maker

1. Remove the exterior and interior packaging. Check if the ice basket and ice scoop are inside.
If any parts are missing, please contact our customer service.
2. Remove the tapes for fixing the ice shovel, ice basket and ice scoop. Clean the tank and ice
basket.
3. Put the ice maker on a level and flat countertop without direct sunlight and other sources of
heat (i.e.: stove, furnace, radiator). Make sure that there is at least a 4-inch gap between the
back and LH/RH sides with the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging the ice maker into the power
supply.
5. The appliance must be positioned in a place where the plug is accessible.
Warning: Fill in with potable water only. Only use drinking water.
Blue:
Brown:
2
Grounding
Neutral
Live