Kasanova SL-CS01 Bedienungsanleitung Seite 6

CORDLESS HAND BLENDER
6
CORDLESS HAND BLENDER
Please read these instructions carefully before use
NOTICE BEFORE USE
To ensure the safety during use and avoid personal injury and damage, please be sure to observe
the following safety precautions.
1. Before using the product, please read this manual carefully and keep it properly for future refe-
rence. Improper use may cause accidents.
2. To prevent from leakage of electricity, do not put the product and USB cable into water or other
liquids.
3. This device may be used by persons with reduced physical, sensory or mental capabilities, or
without experience or knowledge of the device, only under the supervision of a person responsi-
ble for their safety, or if they were instructed on the safe use of the device and are aware of the
dangers associated with its operation. Children should not play with the device. Cleaning and
maintenance of the device should not be carried out by children.
4. Make sure that the switch is off when the product is not in use, disassembled or cleaned.
5. Do not touch the blades as they are very sharp.
6. Do not touch this product by hands, scrapers, spoons and other utensils when it is running.
7. Do not use the product when it is charging.
8. Do not use non-original accessories in order to avoid danger.
9. The product will stop running if you release the switch button.
10. Do not place the product in the places where is close to heat sources, such as electristove,
gas stove, to avoid from causing damages to the product.
11. Do not use the product if any damage or functional fault is found. Do not disassemble, repair
or replace by yourself. Overhaul should be performed by professionals to avoid danger.
12. Even though the product is seriously damaged, do not burn it in order to avoid causing danger
when the battery catches fire.
SAFETY TIPS FOR USB CABLE
1. Do not drag or suddenly pull the USB cable; Do not hang the USB cable vertically on the edge
or at the corner of the table; Do not twist the USB cable tightly round the product. Do not exert
pressure on the USB cable when plugged in the charging port, this may cause wear or breakage
of the USB cable.
2. Please check whether the USB cable has scratches or wear marks each time before charging.
If so, replace the USB cable in time, do not use damaged USB cable to charge the product.
3. Please use the original USB cable of the product for charging. If the original one is lost, please