Factory Reset; Cycle Counter - AEG FSK76748P Benutzerinformation

How to change a setting
Make sure the appliance is in setting
mode.
1. Use Previous or Next to select the
bar of the ECOMETER dedicated to
the desired setting.
• The bar of the ECOMETER
dedicated to the chosen setting
flashes.
• The display shows the current
setting value.
2. Press OK to enter the setting.
• The bar of the ECOMETER
dedicated to the chosen setting is
on. The other bars are off.
• The current setting value flashes.
3. Press Previous or Next to change
the value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
settings list.
5. Press and hold simultaneously
and
seconds to exit setting mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.

6.2 Factory reset

Factory reset restores the factory
defaults. Before the reset, make sure the
appliance is in setting mode.
Press and hold Previous and Next for 5
seconds.
The displays shows _ _ _ for about 5
seconds.
Water hardness
German de‐ French de‐
grees (°dH) grees (°fH)
47 - 50 84 - 90
43 - 46 76 - 83
37 - 42 65 - 75
29 - 36 51 - 64
23 - 28 40 - 50
for about 3
mmol/l
8.4 - 9.0
7.6 - 8.3
6.5 - 7.5
5.1 - 6.4
4.0 - 5.0
The appliance returns to the programme
selection.
Factory reset does not reset
the cycle counter and the
wireless connection setup.

6.3 Cycle counter

You can view the number of completed
dishwashing cycles in the cycle counter.
1. Press and hold the on/off button until
the dishwasher is activated.
2. Press and hold Previous and Next
for 5 seconds.
The displays shows uC and then the
number of cycles.
Press any button to exit the cycle
counter.
After reaching 65535, the
cycle counter restarts.
6.4 The water softener
The water softener removes minerals
from the water supply, which would have
a negative effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. Set the right level of the
water softener to assure good washing
results.
mg/l (ppm) Clarke
degrees
835 - 904 58 - 63
755 - 834 53 - 57
645 - 754 46 - 52
505 - 644 36 - 45
395 - 504 28 - 35
ENGLISH 13
Water softener
level
10
9
8
7
6