Superior Electronics SMART iCM003 Bedienungsanleitung Seite 5

B. "Me"
To access the configuration section, press the icon on the menu bar to the bottom-right.
Once inside, press "Home Management" to add, modify or remove the settings ("Homes")
into which the account can be divided for more effective management of devices. Control
of the "Home" can also be shared with other users ("Home Members" or "Members"). An
administrator of the "Home" can add or remove devices, scenarios or members, or delete
a home ("Delete Home").
3.3 CONNECT YOUR "SECURITY" CAMERA TO THE "SMART LIFE®" ACCOUNT
A. Rapid mode (recommended)
Connect the "Security" camera to the electrical current using the power supply found in
the package. Open the "Smart Life®" application and, after accessing it with the proper
credentials, press the "+" in the upper right and/or press "Add Device". Select "Camera &
Lock" from the left column and then, from the list that opens up, press "Smart Camera
(Wi-Fi)" (even if it is connected via cable).
On the new screen press the key "Next" and then select the network for the connection,
entering the access credentials and confirming. Continue following the instructions on
the screen until a QR code appears.
If the camera is not already making the acoustic signals described under point "3.2
– Installation of the Camera", then press and hold the "RESET" key (see the "Product
Overview" on page 2) until you hear one. The camera will begin to move (ATTENTION:
there may be a wait of up to 30 seconds before this happens). If it does not move, then
check to see that the power supply is functioning properly and repeat the steps.
As soon as the "Security" camera has returned to the original position, it will give off a
new acoustic signal. Position the QR code shown on the screen in front of the lens (at a
distance of roughly 15-20 cm), until the camera makes a higher-pitched signal. Press the "I
Heard a Prompt" key and wait for the connection to be completed (10-60 seconds).
If the synchronisation does not take place correctly, repeat the procedure.
B. Alternative modes (EZ/Cable)
B.1 EZ Mode
If the quick setup fails more than once, you can try the EZ mode.
From the "Home" page, press the "+" at the top-right, and/or "Add Device" in the centre
of the screen. Select "Camera & Lock" from the left column and, from the list that opens,
"Smart Camera (Wi-Fi)".
In the new screen, click on "QR Code" in the upper-right corner, then on "Wi-Fi Mode"
and "Next step".
Check that the camera is making the acoustic signals described under point "3.2 –
Installation of the Camera" before pressing "EZ Mode". (ATTENTION: If the device does
not make any sound, repeat the reset procedure (using the "RESET" button) indicated in
point "A", before proceeding).
Click on "Next", wait for the configuration to be completed successfully and press
"Finish".
Should you encounter difficulties even with the alternative modes, contact "Superior
Electronics" support at the e-mail address: info@superior-electronics.com