Replacement Parts - Koala Kare KB300 Bedienungsanleitung

KB300
Operations Instructions
Please Note
To assure proper installation, it is suggested that
a qualified person or carpenter install the Koala
Baby Changing Station. Koala Kare Products will
not be responsible if the station is not installed
properly. Koala Baby Changing Stations have
been tested to hold a substantial static load. The
unit must be attached to a permanent wall that is
capable of holding a substantial load. The maximum
recommended total weight for this baby changing
station is 11 kg. Excessive weight may cause a
hazardous or unstable condition to exist.
Inspection Criteria
A properly maintained baby changing station:
• Opens and closes smoothly.
• Offers parents liners through a fully stocked liner
dispenser. (Dispenser built into unit.)
• Provides a clean, convenient place for customers
to attend to their children.
EN 12221:2008+A1:2013
WARNING: Do not leave child unattended.
All assembly fittings shall always be correctly
tightened and checked regularly.
Be aware of the risk of open fire and other sources
of strong heat, such as electric bar fires, gas fires,
etc. in the near vicinity of the changing unit.
Do not leave the child unattended. The changing
unit is intended for infants age up to 12 months, with
a maximum weight of 11 kg. Do not use changing
unit if any parts are broken or missing.
A changing pad is not required for this product.
Additional or replacement parts shall only be
obtained from the manufacturer or distributor.
Unit should be cleaned once or more daily with a
clean nylon brush and spray disinfectant.

Replacement Parts

For a list of replacement parts for this product,
(such as straps, shocks and labels) please visit
www.koalabear.com.
Replacement parts and additional liners can be
purchased from your local distributor or direct from
Koala at www.koalabear.com.
3 3