Instructions for use
Gebrauchsanleitung
Before the initial assembly, you have
to measure the top tube width at the
assembly point and, if necessary, glue the
appropriate foam spacer in the arch of the
front bracket centered from below:
Top Tube Width Foam Spacers
33-43 mm
10 mm
44-53 mm
5 mm
54-57 mm
ohne
You can protect the top tube from scrat-
ches at the mounting point of the front
bracket using the frame protection film
(J - cut to size as required).
Vor der Erstmontage musst Du die
Oberrohr-Breite am Montagepunkt
messen und wenn nötig den passenden
Schaumstoff-Distanzhalter in den Bogen
des vorderen Bügels von unten mittig
einkleben:
Oberrohr-Breite Schaumstoff-
Distanzhalter
33-43 mm
10 mm
44-53 mm
5 mm
54-57 mm
ohne
Das Oberrohr kannst Du am Montage-
punkt des vorderen Bügels mittels der
Rahmenschutzfolie (J – nach Bedarf
zuschneiden) vor Kratzern schützen.
9