English; Skimmer For Concrete Pools; Installation Instructions - Pahlen 112979 Installationsanweisung

Skimmer
Position the skimmer in the pool according to your pool supplier´s instructions.
The skimmer is normally positioned at one of the short ends and the inlet nozzles at the opposite end
Follow the instructions below regarding water quality:
Chlorine content: max. 3.5 mg/l
Chloride (salt) content: max. 250 mg/l
pH value: 7.2–7.6
Alkalinity: 60–120 mg/l (ppm)
Calcium hardness: 100–300 mg/l (ppm)
Outside these values the product warranty does not apply.

Skimmer for concrete pools

Short neck
Measurements (mm)
A = 60
B = 30–120
C = 270
Item no. 112972
Item no. 112979
With openings on the back for water filling,
overflow and cable bushing for water level
control.
Measurements
D. Flange
E. Concrete frame
D
E
Iron:
Copper:
Manganese:
Phophforus:
Nitrate:
Standard neck
Measurements (mm)
A = 240
B = 30–120
C = 450
Item no. 112982
Item no. 112989
With openings on the back for water filling,
overflow and cable bushing for water level
control.
240
75
210
245
319
335
NOTE! Minimum distance between stainless steel material and non-stainless
(e.g. Concrete-reinforcing bars) will be 50 mm.
D
E

Installation instructions:

1. Before casting, mask off the skimmer´s opening to avoid any concrete
splashes. A casting attachment (item no. 112900) is available as an
accessory. This stabilizes the position of the skimmer in the concrete.
2. Fit the skimmer to the moulding using the attachment clamps on the flange.
The skimmer´s sealing flange shall be at the centre of the moulding and
the water surface shall be at the centre of the opening. The pool wall is then
chamfered at 45° to the skimmer. (See sketch)
3. Connect the pipe connection using a suitable thread seal.
4. The collar is adapted to the floor covering around the pool and is secured
with the adhesive strip supplied.
5. 5. Fit the inlet gate in the skimmer after casting.
max 0.1 mg/l *
max 0.2 mg/l *
max 0.05 mg/l *
max 0.01 mg/l *
max 50 mg/l*
175
ø6,2 (4x)
2"
45 ø150
C
D
7

ENGLISH

* Complies with EN 16713-3
Extended neck
Measurements (mm)
A = 440
B = 30–120
C = 650
Item no. 112992
Item no. 112999
With openings on the back for water filling,
overflow and cable bushing for water level
control.
A
87,5
35
½"
31
23
ø13
1 ½"