Heidolph Hei-PLATE Mix'n'Heat Expert Betriebsanleitung Seite 124

Appendix
Query compact device info
Command Response
IN_SP_ALL\r\n IN_SP_ALL Z\r\n
IN_PV_ALL\r\n IN_PV_ALL Z\r\n
IN_ MODE _ALL
IN_MODE_ALL\r\n
Z\r\n
Setting set values
Command Response
OUT_SP_1 Y\r\n OUT_SP_1 X\r\n
OUT_SP_2 Y\r\n OUT_SP_2 X\r\n
OUT_SP_3 Y\r\n OUT_SP_3 X\r\n
OUT_SP_4 Y\r\n OUT_SP_4 X\r\n
OUT_SP_5 Y\r\n OUT_SP_5 X\r\n
OUT_SP_6 Y\r\n OUT_SP_6 X\r\n
OUT_SP_7 Y\r\n OUT_SP_7 X\r\n
OUT_SP_8 Y\r\n OUT_SP_8 X\r\n
Setting modes
Command Response
OUT_MODE_2 OUT_MODE_2
Y\r\n Y\r\n
OUT_MODE_4 OUT_MODE_4
Y\r\n Y\r\n
OUT_MODE_5 OUT_MODE_5
Y\r\n Y\r\n
OUT_MODE_6 OUT_MODE_6
Y\r\n Y\r\n
OUT_MODE_7 OUT_MODE_7
Y\r\n Y\r\n
OUT_MODE_8 OUT_MODE_8
Y\r\n Y\r\n
Description
All set points: Z = All X values from IN_SP_1 to IN_
SP_7, separated by semicolon
All actual values: Z = All X values from IN_PV_1 to
IN_PV_11, separated by semicolon
All modes: Z = All Y-values from IN_MODE_1 to 8,
separated by semicolon. The nonexistent value IN_
MODE_3 is replaced by "999" .
Description
Set setpoint temperature, sample/heating plate (°C)
Set setpoint value, safety deltaT (°C)
Set setpoint speed (rpm)
Set setpoint temperature, sample/heating plate (°F)
Set setpoint value, safety deltaT (°F)
Set setpoint value, heating plate max. temperature
(°C)
Set setpoint value, heating plate max. temperature
(°F)
Lower lab jack to Y mm (Ultimate only)
Description
Set behavior after power failure
• Y = 0: All OFF after power restored
• Y = 1: Heating/motor ON after power restored
• Y = 2: Motor ON after power restored
Set heating control
• 0 = heating control in PRECISE mode (without
heating source),
• 1 = heating control in FAST mode,
• 2 = heating control in PRECISE mode (heating
source - HeatOn)
Set motor direction of rotation
• 0 = CCW
• 1 = CW
Set motor acceleration level
• 0 = slow
• 1 = medium
• 2 = fast
Set ext. sensor monitoring
• 1 = on
• 0 = off
Set stir bar detector
• 1 = on
• 0 = off
124