About This Guide - D-Link DGS-1210 Erste Schritte

About This Guide

This guide provides instructions on how to initially install
and configure your D-Link switch. It includes information
about the warranty, switch management options, rack
mount installation and power connections.
The illustrations might be different to the switch you have
purchased. Please refer to the switch's documentation
for detailed information on hardware installation and
software configuration.
Step 1 – Unpacking
Carefully unpack the switch and accessory kit from
the shipping box and check if the following items are
included in the box. If any item is missing or damaged,
please contact your local D-Link reseller for replacement.
• One D-Link Switch
• Rack mounting brackets or Wall mounting brackets
• A power cord and retainer(depending on the
purchased model)
• One console cable (depending on the purchased
model)
• An accessory kit with screws and rubber feet
Step 2 – Switch Installation
For safe installation and operation, it is recommended
that you:
• Visually inspect the power cord to see that it is secured
fully to the AC power connector.
• Make sure that there is proper heat dissipation and
adequate ventilation around the switch.
• Do not place heavy objects on the switch.
Desktop or Shelf Installation
When installing the switch on a desktop or shelf, the
rubber feet included with the device must be attached
on the bottom at each corner of the device's base. Allow
enough ventilation space between the device and the
objects around it.
Rack Mount Installation (depending
on the purchased model)
The switch can be mounted in an EIA standard size
19-inch rack, which can be placed in a wiring closet with
other equipment.
1. Attaching the L-shaped mounting brackets to the sides
of the switch and secure them with screws provided.
2. Mount the switch in the rack using a screwdriver and
the supplied rack-mounting screws.
Wall Mount Installation (depending
on the purchased model)
The desktop size switch can also be mounted on a wall.
Two mounting slots are provided on the bottom of the
switch for this purpose. Please make sure that the front
panel is exposed in order to view the LEDs. Please refer
to the illustrations below:
A.) Mounting on a concrete wall
1. Fix the nylon screw anchors into the concrete wall.
2. Drive the T3 x 15L screws into the nylon screw
anchors.
3. Hook the witch with the mounting holes on the bottom
onto the screws, and it is completed.
B.) Mounting on a wooden wall
1. Drive the T3 x 15 L screws into the wooden wall.
2. Hook the witch with the mounting holes on the bottom
onto the screws.
Grounding the Switch (depending
on the purchased model)
This section describes how to connect the switch to
the ground. You must complete this procedure before
powering on the switch.
Required Tools and Equipment:
• One M4 x 6 mm (metric) pan-head screw (included in
the accessory kit).
• Grounding cable (not included in the accessory kit):
The grounding cable should be sized according to local
and national installation requirements. Depending on
1
2
3