weinor VertiTex II Austauschanleitung Seite 24

VertiTex II | 125103-0000w | v4.0 | 2019-06-25 | Austauschanleitung | Vervangingshandleiding | Replacement instructions | Notice de remplacement
3.2
APPLIES FOR DELIVERED SYSTEMS FROM DECEMBER 2018
Adjusting the end positions and reducing the
load for elero radio motors*
Ro lTop-868 S12 17
SunTop-868 M20 RH
• Preparation for the fully wound up fabric:
First of all, extend the awning using the DOWN key
(this step can be skipped if the fabric was already wound
up in the drop profile by a motor with weight before).
• Move the awning to a centre position using the UP
3
key or DOWN key
removed at least 30 cm from the top housing stop.
• Note: It is only possible to adjust the end position
and activate the load reduction function if the drive
is set to factory settings. So delete any existing end
positions as required:
a.) Restore the power supply after it has been
disconnected
b.) Press and hold down the WT/PROG key until the
drive briefly moves up and down
firms that it has been deleted by briefly moving up and
down.
• Press and hold down the AUF key
moving... briefly stops... and then continues moving...
• Press the DOWN key
profile reach the desired bottom end position. Correc-
tions are possible with the UP and/or DOWN key
The drive starts moving, briefly stops and continues mo-
ving as long as the key is pressed.
• Press and hold down the UP key at the desired bot-
tom end position
stops after approx. 200 mm. The end position adjust-
ment is finished.
• Move up to the bottom end position using the
11
DOWN key
to check the end position setting.
at the bottom end position. Caution: If the awning does
NOT switch off at the bottom end position, start the end
position adjustment again
• For storage and/or transport, extend the awning
fabric a bit (1 cm maximum) using the DOWN key
The drop profile is slightly loose.
• For radio operation, insert the cable bridge again and
reprogram the hand transmitter, if applicable.
AUF
Omhoog
UP
haut
AB
Omlaag
Down
bas
24
Technische Änderungen vorbehalten | Technische wijzigingen voorbehouden | We reserve the right to make technical changes | Sous réserve de modifications techniques
*) The activated load
reduction function can
only be tested in radio
mode
2
. The drop profile has to be
4
.
5
. The drive con-
6
. The drive starts
8
until the fabric and drop
10
. The drive starts moving up and
and then run in using the UP key
Drive switches off
1 12
- .
Somfy adjust-
ment set or
comparable
adjustment kit
(e.g. Becker)
WT
PROG
1
(PROG)
1
2
(PROG)
4
6
7
.
(PROG)
9
.
8 (PROG)
12
(PROG)
10
13
.
(PROG)
11
(PROG)
12
13
(PROG)
3
(PROG)
5
(PROG)
7
9
ca. 200 mm
auto-stopp
auto-stopp
auto-stopp OK
1
ca. 10 mm
12