Troubleshooting; Technical Specifications - cecotec BOLERO COOLMARKET COMBI 250 WHITE E Bedienungsanleitung

ENGLISH
benzine, petrol, acid, hot water or other corrosive elements to clean the refrigerator
surface, door gasket, plastic decorative parts, etc., to avoid damage.
- Carefully dry the door gasket and clean the slot with a wooden stick wrapped with cotton.
After cleaning, fix the four corners of the door gasket and then gradually push it into the
slot in the door.
Power failure or cooling system fault
- If you receive an early power failure warning
- Activate the fast freeze function, so that food is completely frozen. Set the temperature
back to the original setting when the power supply returns to normal.
Note:
It is advisable to run the refrigerator uninterruptedly once you start using it.
Defrost
- This refrigerator includes an automatic defrost function, so there is no need to defrost it
manually.
Light bulb replacement
- The refrigerator has a LED light with low consumption and a long shelf life. In the event
of an anomaly, please contact the technical support service. Lights or other parts of the
appliance may only be replaced by the manufacturer.
Removing the shelves
Hold the shelves with both hands and push them upwards.
Hold one end of the shelf and lift it up while pulling it out. (Fig. 25)

7. TROUBLESHOOTING

For the following minor malfunctions, please try to solve the problem yourself before
contacting Cecotec Technical Support Service.
Fault Possible causes
The The refrigerator is not connected to
refrigerator the mains.
does not work. The circuit breakers or fuses are
damaged.
There is no power or the fuse trips.
B OL E RO COO LMARKET CO MBI 2 50 W H IT E E
74
B OL E RO COO LMARKET CO MBI 2 50 IN OX E
Possible solutions
Plug the refrigerator into the mains.
Open the door and check the light
is on.
The refrigerator is not stable.
Abnormal The refrigerator is in contact with
noise the wall.
Low cooling The food introduced is hot or there
efficiency is too much food.
You open the door too often.
The door gasket has objects that do
not allow to close it completely.
The refrigerator receives direct
sunlight or is close to a heat source.
The refrigerator is not well
ventilated.
The selected temperature is too
high.
Unpleasant There is spoiled food inside.
smells in the The refrigerator is dirty.
refrigerator You introduced food with strong
smells.
The LED The door has been open for more
light flashes. than 10 minutes.
Note: if none of these situations match your problem, do not attempt to disassemble or repair
the device by yourself. Repairs carried out by unqualified persons may result in injury or serious
malfunctions. Please contact the local store where you made your purchase. The repair must
be carried out by an authorised technician, and you must use only original spare parts.

8. TECHNICAL SPECIFICATIONS

Product Bolero CoolMarket Combi 250
White E
Reference: 02435
QR code
BO LER O CO O LMA R KET CO MBI 25 0 WHI TE E
B O LER O CO O LMA R KE T CO MB I 25 0 I N OX E
ENGLISH
Set the adjustable feet of the
refrigerator.
Separate the refrigerator from the
wall.
Introduce food in the refrigerator
when it is at room temperature.
Check and close the door.
Remove the refrigerator from the
heat source.
Keep the recommended distances
in the installation section so the
refrigerator is well ventilated.
Set a suitable temperature.
Dispose of food which is spoiled.
Clean the refrigerator.
Pack food, especially if it has a
strong smell.
Close the refrigerator door, open it
again within 2 seconds, checking if
the LED light is working normally.
Bolero CoolMarket Combi 250 Inox E
02436
75