Troubleshooting - cecotec BOLERO COOLMARKET COMBI 356 WHITE D Bedienungsanleitung

ENGLISH
benzine, petrol, acid, hot water or other corrosive elements to clean the refrigerator
surface, door gasket, plastic decorative parts, etc., to avoid damage.
- Carefully dry the door gasket and clean the slot with a wooden stick wrapped with cotton.
After cleaning, fix the four corners of the door gasket and then gradually push it into the
slot in the door.
Power failure or cooling system fault
- If you receive an early power failure warning:
- Activate the fast freeze function, so that food is completely frozen. Set the temperature
back to the original setting when the power supply returns to normal.
Note:
It is advisable to run the refrigerator uninterruptedly once you start using it.
Defrost
- This refrigerator includes an automatic defrost function, so there is no need to defrost it
manually.
Light bulb replacement
- The refrigerator has a LED light with low consumption and a long shelf life. In the event
of an anomaly, please contact the technical support service. Lights or other parts of the
appliance may only be replaced by the manufacturer.
- Energy efficiency level: G
Removing the shelves
Hold the shelves with both hands and push them upwards.
Hold one end of the shelf and lift it up while pulling it out. (Fig. 25)

7. TROUBLESHOOTING

For the following minor malfunctions, please try to solve the problem yourself before
contacting Cecotec Technical Support Service.
Fault Possible causes
The The refrigerator is not connected to
refrigerator the mains.
does not work. The circuit breakers or fuses are
damaged.
There is no power or the fuse trips.
B O L E R O CO O LMARKET CO M BI 3 5 6 W HI TE /IN OX /
76
DA R K/WHIT E GLASS/ BLAC K GLASS D
Possible solutions
Plug the refrigerator into the mains.
Open the door and check the light
is on.
The refrigerator is not stable.
Abnormal The refrigerator is in contact with
noise the wall.
Low cooling The food introduced is hot or there
efficiency is too much food.
You open the door too often.
The door gasket has objects that do
not allow to close it completely.
The refrigerator receives direct
sunlight or is close to a heat source.
The refrigerator is not well
ventilated.
The selected temperature is too
high.
Unpleasant There is spoiled food inside.
smells in the The refrigerator is dirty.
refrigerator You introduced food with strong
smells.
You cannot Check if the Smart or fast freeze
set the functions are not active on the
temperature. control panel.
The Check that the power supply has not
temperature been cut off before.
on the freezer
compartment
is shown on
the panel, but
it flashes.
Note: If none of these situations match your problem, do not attempt to disassemble or repair
the device by yourself. Repairs carried out by unqualified persons may result in injury or serious
malfunctions. Please contact the local store where you made your purchase. The repair must
be carried out by an authorised technician, and you must use only original spare parts.
B O L ER O CO O LMA R KE T CO MB I 3 5 6 W HI T E/I N OX/
DA R K/ WHI T E GLA S S /B LACK G LA S S D
ENGLISH
Set the adjustable feet of the
refrigerator.
Separate the refrigerator from the
wall.
Introduce food in the refrigerator
when it is at room temperature.
Check and close the door.
Remove the refrigerator from the
heat source.
Keep the recommended distances
in the installation section so the
refrigerator is well ventilated.
Set a suitable temperature.
Dispose of food which is spoiled.
Clean the refrigerator.
Pack food, especially if it has a
strong smell.
Deactivate the special functions and
then set the temperature (for more
details, check the Functions section).
Press any button to activate the
alarm (check the overheating
warning section) and check that the
food inside the refrigerator is not
spoiled.
77