Troubleshooting - cecotec bolero AGUAZERO COOLMARKET 1D 242 WHITE Bedienungsanleitung

ENGLISH
warm water using a wrung-out cloth or sponge. Dry it completely before placing the shelves
and the crisper drawer back. Dry all the surfaces and the detachable parts thoroughly before
placing them back in place.
Defrost
Water on food or water that gets into the air inside the refrigerator when opening and closing
the doors can form layers of frost inside the refrigerator. When frost is thick, it will reduce the
cooling power. When it is thicker than 10 mm, it must be defrosted in the refrigerator.
Control defrosting by turning the temperature selector on or off so that defrosting is not
necessary. The defrost water will automatically drain into a drip tray through a drain pipe at
the rear of the refrigerator.
Substitution of the LED light
Warning
The LED light can only be substituted by authorised personnel. If the LED light is damaged,
contact the official Customer Service of Cecotec for assistance.
Turning off the refrigerator
If it were necessary to turn off the refrigerator for a long period of time, you should follow
these steps to prevent fungus or mould formation in the refrigerator.
1. Remove all the food.
2. Turn off the refrigerator by placing the knob on the 0 position and disconnect the plug
from the power socket.
3. Clean and dry the interior completely.
4. Make sure all doors are slightly open to allow air flow.

7. TROUBLESHOOTING

If you experience any problem with the refrigerator or you think it does not work properly, you
can carry out a few simple checks before calling the official Cecotec Customer Service.
Warning
Do not try to repair the refrigerator on your own. If the problem persists after the checks
explained below, contact a qualified electrician, authorised personnel or the store where you
purchased the product.
60
Problem Possible cause
The refrigerator does not The refrigerator is not on.
work.
The device is not correctly
connected to the power
socket.
The fuse has blown or is
faulty.
The power socket is faulty.
The refrigerator cools too The temperature setting is
much. too low.
Food is too hot. The temperature is not
correctly adjusted.
The door was open for a long
period of time.
You have stored a great
amount of food in the
refrigerator in less than 24
hours.
The refrigerator is close to a
heat source.
The interior light does not The light bulb is faulty.
work.
There is too much frost, The door gasket/draught
maybe also on the draught excluder is not airtight
excluder. (maybe after changing the
door opening direction).
ENGLISH
Possible solution
Turn on the refrigerator.
Plug the device to the power
socket.
Check the fuse and contact an
electrician if necessary.
Faulty parts must be repaired
by an electrician.
Adjust the temperature to a
higher level.
Check section 5 ( Operation)
Open the door only during the
necessary time.
Adjust the temperature to a
colder level.
Check section 3 ( Installation)
The light bulb can only be
replaced by authorised
personnel.
Contact the official Technical
Support Service of Cecotec.
Carefully heat the leaking
sections of the door gasket
with a hair dryer. WARNING:
Be careful not to burn
yourself with the hair dryer.
Simultaneously, shape the
heated door gasket with your
hand so that it fits properly.
61
COOLMARKET 1D 242 WHITE