Cleaning, Care & Maintenance; Emptying The Appliance - NISBETS ESSENTIALS DF524 Bedienungsanleitung

Operation
Nisbets Essentials recommend that the appliance is cleaned out before using for the first time, or if the
appliance has been sat unused for an extended period of time.
1. Put the drip tray in place (if necessary).
2. Connect to the mains power supply. The appliance is powered up at once and shows "OFF".
3. Press the "ON/OFF" switch. The display shows the temperature first, then flashes "ELL".
4. The "Refilling" indicator light and the "No Water" indicator light illuminate together. The appliance then
starts automatic filling.
5. After filling, the "Heating" indicator light illuminates indicating the appliance starts to heat water; when
the light off, heating stops indicating a rapid heating cycle has been completed.
6. When the "Ready" indicator light illuminates, the water has reached pre-set temperature and ready for
drinking.
7. Dispensing water: Place a vessel beneath the tap and pull the tap handle towards you to begin dispensing.
Raise the tap handle to close the tap.
8. Use the first 2/3 boiling cycles to test the water connection and flush out the system. Discard the hot
water from these initial cycles.
NOTE: Before the boiler chamber is full, the boiler will automatically keep running the "filling-
then-heating" cycle. When the "Ready" indicator light comes on and the display shows "98°C",
the water has reached the pre-set temperature and suitable for drinking.
NOTE: During operation, steam may rise from the appliance and loud bubbling noises may be
heard. This is perfectly normal.
9. To turn off the appliance, press the "ON/OFF" switch for 5 seconds. The display will show "OFF".
Cleaning, Care & Maintenance
Warning: Before cleaning and maintenance, always turn off the appliance, disconnect it from
the power supply, and let it cool sufficiently.
• Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
• DO NOT use abrasive cleaners or pads.
• Dry thoroughly after cleaning.

Emptying the appliance

In case the appliance will not be used for an extended period
of time, empty it thoroughly.
1. Turn off the water supply.
2. Remove the cap from the drain outlet (on the bottom)
and let water flow into a suitable container.
3. Re-locate the cap in place afterwards.
DF524_ML_A5_v2_20230407.indb 5 DF524_ML_A5_v2_20230407.indb 5
EN
Drain outlet
5
2023/4/7 10:08 2023/4/7 10:08