Control Panel - NISBETS ESSENTIALS DF524 Bedienungsanleitung

EN
Installation
Notes:
• The appliance should be disconnected from the power supply during installation.
• The appliance should not be left unattended for long periods of time.
• The appliance will become hot so must be placed on a suitable heat and steam resistant surface. It is not
suitable for polished wood surfaces.
• Maintain a distance of 50cm between the appliance and walls or other objects for ventilation.
• We suggest installing a water filtration system in the case of a hard water supply.
1. Connect the water inlet hose (supplied) to the
appliance then to the water supply.
2. Ensure the water pressure of the connected water
supply is between 0.2-0.6Mpa (Flow rate ≥ 4L/min).
3. Ensure the water temperature of the connected water
supply is between 0-40°C.
4. The use of a stop cock is recommended to isolate the
unit from the water supply for servicing.
Note: Only use the water inlet hose supplied with the appliance. Other hoses are not suitable
and should not be used.

Control Panel

"Heating" indicator light: When lit,
the appliance starts to heat water;
when off, heating stops and water
has reached pre-set temperature.
"No Water" indicator light: When lit,
the appliance is low in water and auto
filling of water starts. When off, water
filling stops.
"ON/OFF" switch: To turn on/off the
Water boiler
4
DF524_ML_A5_v2_20230407.indb 4 DF524_ML_A5_v2_20230407.indb 4
Attach the water inlet hose here
Display: To show the water
temperature or error code
"Refilling" indicator light: When lit,
auto filling of water starts; when off,
water filling stops.
"Ready" indicator light: When
lit, water has reached pre-set
temperature and ready for drinking;
when off, water not ready yet.
"Error" indicator light: When lit,
there is something wrong with the
appliance. Meanwhile, relative error
code will be shown on the display.
Water inlet:
2023/4/7 10:08 2023/4/7 10:08