2.
Tilt the chair to the reclined position (see section
5.5).
3.
Slide the footrests onto the support tubes.
4.
Set the footrest to the required height, align the
holes, and insert the height adjustment clips (A).
5.
Return the chair to an upright position.
4.2 Fitting the Foot-Straps
1.
Release the plastic adjustment buckle, and
thread the webbing through the slots in the
footrests, leaving the buckle uppermost.
2.
Feed the loose end of the strap through the
buckle and fasten securely.
4.3 Fitting the Liners (Optional)
The chair is supplied without liners fitted.
There are two liner sizes for each chair model (see
section 3.2 for details).
If liners were ordered at the time of purchase, they
will be included in the delivery.
Note: We recommend you fit the seat liner before
fitting the back liner.
1.
Remove the liners from the packaging, and
insert into the chair seat as shown.
2.
Make sure the liners are pushed firmly into the
slots in the back of the seat moulding.
4.4 Fitting the Pommel
The pommel can be used to help position the user. It
also helps secure the seat liner in position.
Note: The pommel should be fitted AFTER fitting
the liners.
WARNING: Take care when inserting the pommel
to minimise the risk of entrapment of the user.
Slide the pommel onto the seat locating ribs and
push firmly until it clicks into place.
4.5 Fitting the Headrest
CAUTION: We strongly recommend the use of
the headrest to fully support the users head and
neck, most importantly when the chair is being
tilted.
1.
With the chair seat in the upright position, locate
the slot for the headrest at the top of the chair.
3