xjump XJ 100 Bedienungsanleitung Seite 15

BLUETOOTH
BLUETOOTH CONNECTION METHODS
1. Power On the speaker, the working state Led (6) will flash in Green;
2. Enable Bluetooth on your mobile device (mobile phone, PC, Tablet) to search Bluetooth device;
3. Search for Bluetooth devices and select "XJ 100"; the device will automatically pair and connect.
Successful connection will deliver reminding tone and the working state Led (6) will turn to
Green (In general case, no password is needed; for special mode, output password, input "0000");
4. The successfully paired device can be automatically connected for the next switch-on.
Note:
- The speaker will power off automatically if no connection withing 20 minutes.
- Press and hold
Bluetooth device will connect with the speaker.
COMANDS AVAILABLE IN BLUETOOTH MODE
- Press and hold the key
for a few seconds to go to the previous song;
- Press the button
HANDS-FREE MODE FOR CALLS
If connected to a telephone, you will hear a beep when a call is received.
- Press the button
- Press and hold the button
button (7) 2 seconds, the speaker will disconnect with the Bluetooth device, other
(3) for a few seconds to go to the next song, keep the key
(1) to pause, press it again to resume
(7) once to answer an incoming call, press it again to end the
(7) for 2 seconds to reject the call.
playback.
English
(4) pressed
call;
15