MALTEC DH-12200 Bedienungsanleitung Seite 32

 Empty the water into an area with a drain or outside.
Clean the inside of the tank as well as the outside.

 Replace the empty tank back into the unit.
 Press the POWER button to resume operating.
 If the Water Full light does not extinguish, check that the float is correctly in place.
Warning
Do not discard water tank magnets and plastic rivets. Otherwise, the machine will not
automatically stop working when the water tank is full, and the condensed water will
overflow and damage the floor of the room.
Please be sure to clean the condensed water in the water tank before resetting the
working mode of the machine.
If the water tank is dirty, rinse it with clean water. Avoid using detergents, steel balls,
chemical dust removers, diesel oil, benzene, diluents or other solvents. Otherwise, the
water tank will be damaged and leak
Replace the empty tank back into the unit.
red and the machine cannot restart.
Otherwise, the water full indicator may remain
32/ 56