Answering A Call; Adjusting The Volume - 2GO Active BT1 Bedienungsanleitung

Turning On The Headset
In OFF MODE, press and hold MFB for 1 second, until you hear "Power on", the indicator
light turns blue for 6 seconds, then the headset will enter into ON MODE.
Turning Off The Headset
In ON MODE (except call state), press and hold MFB for 3 seconds, until you hear "Power
off", the indicator light turn red for 1 second, then the headset will enter into OFF MODE.
Note: Headset isn't connected with any devices within 7 minutes (including 1 minute
searching time), it will automatically turn off.
Pairing Your Headset With A Bluetooth Phone
• Ensure the headset is off, and the distance between your headset and phone is within
1 meter to activate the Bluetooth function on the phone.
• Press and hold MFB until the indicator light flashes blue and red alternately and could
hear "Bluetooth Mode" as PAIRING MODE.
• Search Bluetooth devices (see the user guide of your phone for instructions).
• Select headset "2GO BT2" from the found devices list of the phone.
• After waiting for a few seconds, enter into pairing code "0000", you could hear "con-
nected". It is connected successfully. (If the pairing cannot be completed whithin 1
minute, the headset will enter into disconnected standby mode, press MFB will enter
into Pairing Mode again).
• Ensure the distance between your headset and phone is within effective distance and
there is no obstacle, you can use the headset to answer calls and do other operations.
• When the headset is off, it will connect the paired phone automatically if you turn on
the headset again within operation range.

Answering A Call

When a call is coming, you could hear the ring tone and incoming call numbers voice
prompt, you can answer it with the ways as follows:
Method 1: Press MFB once.
Method 2: Answer the call with your phone.
Ending A Call
You can end the call you are answering with the ways as follows:
Method 1: Press MFB once, you will hear "Hang up".
Method 2: End the call with your phone.
Rejecting a Call
Press and hold MFB for 2 seconds to reject the call, you will hear "Call Rejected".

Adjusting The Volume

In call or playing music state, long press V+ or V- to adjust the volume. When the vo-
lume up to maximum, you could hear "Volume Maximum". When the volume down to
minimum, you could hear "Di,Di".(There is no any voice prompt when you adjust the
volume in the call.)
Last Number Redialing
In STANDBY MODE, press MFB twice, the headset will automatically redial phone last
dial out the number.You will hear "Call back".