Maintenance; Fan Maintenance; Maintenance Of The Edge Sensors - Zoef Robot Bobbie 2.0 Anweisungen

5. Maintenance

5.1 Cleaning cloth maintenance
Remove the cleaning cloth from the robot and immerse it in cold water, wash the cloth with detergent and let it
dry. You can also wash it in the washing machine at 30°C.
Please remember:
Do not use bleach, do not tumble dry or sun dry, do not dry clean.
Do not use a completely wet cloth to clean the glass window. The machine may stick due to excessive moisture
on the glass surface and will not be able to move.

5.2. Fan maintenance

Place Bobbie 2.0 on the back and use a clean and dry cloth to remove any dirt/debris on the fan.

5.3 Maintenance of the edge sensors

Put Bobbie 2.0 on the back and use a clean and dry cloth to remove any dirt/debris on the sensors.
5.4 Transmission maintenance
Place Bobbie 2.0 on the back and use a clean and dry cloth to remove any dirt/debris on the transmission.
Wash cleaning Clean fan Clean edge sensors clothes
Clean transmission
5.5 Cleaning belt stains automatically
Every time the user uses the window cleaner (before and after cleaning). Make sure to clean the belt. Prevent
the surface of the belt from sticking to dirt, dust, etc. Causes the machine to run abnormally.
Steps for automatic belt cleaning:
A. Plug in the POWER adapter and start the machine normally (long press the POWER key).
B: Place the machine in the opposite direction (belt up) on the surface.
C: Press a sensor (one of the four corners) with your hand for a long time (about 8 seconds). Then the machine
automatically enters the belt cleaning mode, the transmission wheels on both sides rotate automatically and
the suction motor stops.
D: Finally, use a clean towel, clean cloth, slightly adsorbed on the surface of the belt. See figure 4.
E: After cleaning the belt, long press the ON/OFF button to power off.
8