Insert The Plug Into The Socket; Use Bobbie; On/Off Button; Starting Bobbie 2.0 - Zoef Robot Bobbie 2.0 Anweisungen

3. Usage

3.4 Insert the plug into the socket

8. Plug Bobbie 2.0 into a wall socket
Important Note:
Make sure that Bobbie 2.0 is always connected to a properly working wall socket. Do not
use Bobbie 2.0 if the backup battery is not full. Remove Bobbie 2.0 from the window as
soon as possible after the power has been (accidentally) cut o /failed.

4. Use Bobbie 2.0

4.1 On/Off Button

A. On/Off button - Press the on/off button for 2 seconds to turn on Bobbie 2.0.

4.2 Starting Bobbie 2.0

A. Place Bobbie 2.0 firmly on the window.
B. Press the on/off button again to start Bobbie 2.0.
C. You can also use the "START" button on the remote control.
Caution: Before starting make sure that Bobbie 2.0 is placed at least 8cm from the edges
and corners. (see picture below).

4.3 Stop/Pause

A. While Bobbie is cleaning, press the
make Bobbie stop.
B. When Bobbie is cleaning press the Pause button
C. The robot can also be started by pressing the START button

4.4 Remote Control

Spray water; On/o
No function
Automatic "Z"
Cleaning mode
Automatic "N"
Cleaning mode
From "Z" to "N" Cleaning
mode
Start standard cleaning N
pattern
button on the robot or the
on the remote control to pause/restart.
Manually up
Manual down
Manually right
Manual left
Stop/Restart
Stop Cleaning
button on the remote control to
on the remote control.
※This is a 2.4G wireless remote control,
which can be used to control the robot. It
has a maximum range of 8 metres in all
directions.