Overheating Protection; Technical Specifications - Clatronic KH 3433 Bedienungsanleitung

Instructions for use (Figure 3)
Thermostat
The thermostat (IV) is a temperature-dependent switch.
Function switch
Heater
The heat output is determined by the power settings. Up to
3 settings can be selected to optimise the heat output:
Function switch I
=
Function switch II
= 1250 W
Function switch I + II = 2000 W
Fan
You can use the fan (III) independent from the heater.
Operation
You can use the appliance for the following applications:
a) Setting the heater appliance to three levels.
The thermostat must be turned on for that purpose.
b) Turning on the fan.
The thermostat must be turned on for that purpose.
c) Turning on the heater and the fan.
The thermostat must be turned on for that purpose.
d) Setting the room temperature.
e) Keeping a room above freezing.
NOTE:
The control lights of the function switch indicate the mode.
Getting the room to the desired temperature
1. Turn the control of the thermostat to the position "MAX".
2. Turn on one or both function switches of the heater. The
control lights in the switches will be lit.
3. After the desired room temperature has been reached,
slowly turn the control of the thermostat back until the appli-
ance turns off. The control lights will go out.
NOTE:
The thermostat will maintain the set room temperature. The
heater appliance and possibly the fan will automatically be
turned on and off in the process.
Frost protection
NOTE:
The frost protection is dependent on the size of the room.
1. Turn the control of the thermostat as far as it will go to the
position "MIN".
2. Turn on both function switches of the heater.
In this position, the heater appliance will constantly maintain the
temperature above freezing.
750 W
Turning off
1. Turn the function switch off. The control lights will go out.
2. Turn the temperature regulator as far as it will go to the
position "MIN".
3. Disconnect the power supply from the socket.

Overheating protection

The appliance is fitted with an overheating protection, which will
automatically turn off the appliance in case of overheating.
• Turn off the function switch. Turn the temperature regulator
to the position "MIN". Unplug the power cord. Let the appli-
ance cool down for approximately 10 minutes before you
use it again.
Has the appliance become overheated? Check whether
•
the air intake or vent on the heater is blocked. If necessary,
clear the blockage.
• In the event that the overheating protection turns off the ap-
pliance after a brief period, then there is probably a defect.
Turn the appliance off again and unplug it from the mains.
• Have the appliance checked by the dealer or by our
service.
Cleaning
WARNING:
• Before cleaning, always remove the mains plug and wait
until the device has cooled down.
• Do not immerse the device in water. Otherwise this might
result in an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Wipe off the dust on the appliance with a dry cloth.
• A damp cloth (not wet) may be used for the removal of
stains.

Technical Specifications

Model: ..............................................................................KH 3433
Power supply: ....................................................... 230 V~, 50 Hz
Power consumption: ........................................................ 2000 W
Protection class: ........................................................................... I
Net weight: ........................................................... approx. 3.85 kg
Subject to change without prior notice!
This device complies with all current CE directives, such as
electromagnetic compatibility and low voltage directive and is
manufactured according to the latest safety regulations.
27