Denver CRB-619 Bedienungsanleitung Seite 8

SPECIFICATIONS
Frequency range
Battery backup
Power Adaptor
RESETTING
If the system does not respond or exhibits erratic or intermittent
operation, you may have experienced an electrostatic discharge
(ESD) or a power surge that triggered the internal microcontroller
to shut down automatically. If this occurs, simply disconnect the ac
power cord and remove the system backup battery, wait for at least
3 minutes and then setup the unit again as if it is a brand new unit.
1. No naked flame sources, such as lighted candles, should be
placed on the apparatus.
2. Do not place the product in closed bookcases or racks without
proper ventilation.
3. The mains plug is used as the disconnect device, the disconnect
device shall remain readily operable.
4. The ventilation should not be impeded by covering the
ventilation openings with items, such as newspapers, table-
cloths, curtains, etc.
5. It shall not be exposed to dripping or splashing and that no
objects filled with liquids, such as vases, shall be placed on the
apparatus.
6. Do not connect FM antenna to outside antenna.
7. The unit should not be exposed to direct sunlight, very high or
low temperature, moisture, vibrations or placed in dusty
environment.
8. Do not use abrasive, benzene, thinner or other solvents to
clean the surface of the unit. To clean, wipe it will mild non-
abrasive detergent solution and clean soft cloth.
9. Never attempt to insert wires, pins or other such objects into the
vents or opening of the unit.
10. Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
11. Attention should be drawn to the environmental aspects of
battery disposal.
: 87.5 – 108 MHz
: 3V ("AAA" batteries x 2) not included
: Input AC 100-240V 50- 60 Hz
Output DC 5V 1500mA
WARNING
ENG-7