Warranty Disclaimer - Hama Magnet Bedienungsanleitung

Note
• Before installing the bracket, check the installation options in your vehicle. If in doubt, check the
vehicle's instruction manual or contact the vehicle manufacturer.
• Check the load-bearing capacity of the slats before inserting a device into the bracket. This installation
version is only recommended for devices < 300 g.
• Never apply force when using the product or during installation.
Note
• Be aware that the preferred adhesive surface (e.g. back of the mobile phone, satnav, etc.) must be free
from dust and grease. Use a suitable cleaner from a specialist retailer for this.
• Be aware that car care products (e.g. dashboard spray) can influence the pad's ability to stick. You
should therefore clean the surface carefully before attaching the pad.
• Various environmental influences, such as moisture in the air, sunlight, cold, etc., can impair the long-
term stickiness of the adhesive pad.
• Possible residue on the mounting surface after removal of the adhesive pad cannot be ruled out.
• Be aware that the mounting surface will only achieve its full load-bearing capacity after around 24
hours.
• Be aware that, depending on the thickness of the protective cover, the magnetic adhesion effect may
be impaired.
• Be aware that dust and dirt between the mobile phone and the inserted magnetic pad can cause
scratches.
• Be aware that the inserted magnetic pad is made from metal and therefore may impair your mobile
phone's sending and receiving capabilities.
• Remove the protective film (1) from the adhesive side of the magnetic pad and press it into the desired
position in your vehicle (2) for a few seconds.
• Remove the protective film (3.a) from the adhesive side of the metal plate (round or rectangular) and press
it onto the desired mounting surface (e.g. rear of the mobile phone) for a few seconds.
• The metal plate (3.b) can simply be inserted/stuck between the protective cover and the rear of the mobile
phone.

5. Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the product or from failure to observe the operating instructions and/
or safety notes.
7