Xblitz Master 200 Benutzerhandbuch Seite 8

To enter FM mode, press the MODE button briefly. For automatic program-
ming of radio stations, press the PLAY/PAUSE button. The unit will scan the
frequencies in the broadcast band 87.5 - 108 MHz and assign sequential
numbers to the available radio stations. These will be stored in the speaker's
memory. To switch between the preset radio stations, briefly press the F+
or F- button.
Note: To improve the quality of radio reception, it is recommended to plug
the supplied USB cable into the micro-USB port on the device.
3. Playback from external storage media
The device plays .mp3 files from external storage media - USB flash drives
and micro-SD cards. To switch to the playback of .mp3 recordings, simply
place the selected storage medium in the corresponding slot on the
loudspeaker. To switch between tracks, briefly press the F+ or F- buttons. To
switch to the first or last track on the memory medium respectively, press
the MOVE TO START or MOVE TO END button. Briefly pressing the POWER
button stops playback from the memory medium.
Note: to avoid the possibility of damaging the storage medium, it is recom-
mended to connect and disconnect it when the device is switched off.
4. Clock and alarm settings
Clock and alarm settings are available in both BT and FM modes.
To set the clock, hold down the SET button, then use the numeric keypad to
set the current hour and briefly press the SET button to move on to setting
the minutes . Confirm the operation by holding down the SET button.
Press the SET button briefly to access the settings. The alarm icon will be
highlighted on the display of the unit. Then hold down the SET button and
set the selected alarm time in the same way as setting the clock. Activate/
deactivate the alarm by briefly pressing the SET button. The highlighted icon
of the selected alarm on the display indicates that it is active, Pressing the
SET button twice takes you to the alarm volume setting. Five volume levels
are available.
5. Display brightness adjustment
Four display brightness levels are available (default setting cycle: 2-3-0-1-2).
To switch between brightness levels hold down the MODE button.
Note: The brightness of the display affects the battery life. The higher it is,
the higher the battery consumption will be.
05. CHARGING
1. do not immerse the appliance or any of its parts in water. Do not use the
8