Charging The Device; Device Functions - Xblitz Master 200 Benutzerhandbuch

1. Numeric buttons
2. Microphone
3. F+ button
4. F- button
5. SET button
6. M button (MODE)
7. MOVE TO START button
8. MOVE TO THE END button
9. Button -
10. Button +
11. ON/ OFF button
12. AUX socket
13. Micro-USB socket (device charging)
14. USB flash drive socket
15. Micro-SD card slot

03. CHARGING THE DEVICE

When the device's battery is about to run down, the speaker will start beeping. To
recharge the device, connect it to the charge using the USB cable supplied. A fully
charged battery allows the device to operate continuously for approximately three
hours at medium volume.

04. DEVICE FUNCTIONS

1. Bluetooth mode
When the device is switched on, Bluetooth mode, which is the default mode
of operation, will automatically turn on. The speaker will confirm the activa-
tion of BT mode with a sound and visual message on the display. Before first
use, pair the speaker with the selected device by activating BT connectivity
on the latter and select XBLITZ MASTER 200 from the list. Successful connec-
tion will be confirmed by an audible message from the speaker.
To switch to the next track, briefly press the F+ button. To switch to the pre-
vious track, briefly press the F- button. To increase or decrease the volume,
hold down the + button or the - button respectively. Briefly press the M
button to switch the unit to FM mode.
During a phone call, the announcer will read out the caller's phone number,
then start beeping the incoming call. Briefly press the PLAY/PAUSE button
to answer the call or hold the same button to reject the call. Note: as the
selected speaker model is not equipped with a microphone when using
hands-free mode, you must use the microphone on your phone.
2. FM mode
7