Disposal; Mounting Installation - TERMOFOL TF-SW300 Installations- Und Bedienungsanleitung

2.4 Disposal

This marking indicates that this product should not be disposed with other ho-
usehold wastes throughout the EU. To prevent possible harm to the environ-
ment or human health from uncontrolled waste disposal, recycle it respon-
sibly to promote the sustainable reuse of material resources. To return your
used device, please use the return and collection systems or contact the reta-
iler where the product was purchased. They can take this product for environ-
mental safe recycling.

3. Mounting Installation

Note: The kit supplied in the package is designed for mounting vertically on a solid wall. If
mounted onto other types of walls, you will need appropriate fixings (not supplied). Please
make sure the wall is safe to mount. We highly recommend to have the panel installed by
a qualified electrician or installer authorized by Termofol. The heater must be at least 20
cm removed from all objects, walls, etc.; the distance to the floor must be at least 20 cm.
Step 1. Use the supplied tem-
plate to mark the position of the
holes on the wall.
Step 2. Drill holes using a 8mm
drill.
Step 3. Insert the dowels into
the holes.
Step 4. Screw in the supplied
screws to the wall.
Step 5. Mount the panel on the
screws.
Step 6. Move the panel to the
right and then down until it's se-
cured.