Toro TEMPUS AIR PS Bedienungsanleitung Seite 2

INTRODUCTION
The Tempus Air PS is a sensor device powered by a 9V battery and used only for reading and controlling the
pressure of your irrigation system. Thanks to the prewired pressure sensor, the Tempus Air PS will put the pressure
under control and will alert if the tresholds are exceeded. The tresholds can be set from the MyToroTempus
application or platform. Tempus Air PS transmits data via LoRa
SPECIFICATION
DIMENSIONS
Width : 10,5 cm
Height : 4,8 cm
Depth : 11,6 cm
FEATURES
Bluetooth® Smart 4.0 Low Energy
LoRa radio communication
TM
POWER SUPPLY
9V 6AM6 ou 6LR61 Alkaline battery
(not included)
Current consumption : 0.1mA
Sensor power supply : 5VDC (TBTS)
Installing the wrong type of battery may cause an explosion or fire hazard.
INSTALLATION GUIDELINES
The Tempus Air PS is made for an outdoor use. You can place it in a buried valve box or set it on a wall (concrete,
brick, cinder blocks).
In order to clean the Tempus Air PS, use soapy water with a sponge and then a soft cloth to wipe it off.
When replacing the sensor, only use a sensor with a waterproof connector (MIPAG1XX004BAAAX).
connection to a Tempus Air gateway.
TM
USE
Operating temperature : -20°C to 50°C
Indoor and outdoor use
Use in humid environment IP68
(test conditions: 1h at 1m depth)
Altitude use up to 2000m
Polution level 2
LoRa Range 800m (Line of sight)
TM
Maximum relative humidity of 80% for temperatures up to 31°C
and linear decrease up to 50% of relative humidity at 40°C.
INSTALLATION
1 Pressure Sensor
Pressure : 0 to 16 bars
Screw thread : G1/4 EN837
Toro Tempus Air PS
2