Environmental Protection - Strend Pro SDDR-140 Gebrauchsanweisung

- Allow the cutting wire holder and the cutting wire to cool completely after cutting.
Types of cuts:
Rectangle
Quadrilateral
Oblique cut
Step cut
U-shaped cut
- WARNING: Excessive pressure on the cutting wire can cause damage to the device. Use only the power
necessary to make the cut. The cutting wire should be hot while making the cut.
- Keep the polystyrene cutter clean. After finishing the work, wipe the surfaces free of dust.
The crossed-out wheeled-bin symbol on the products or accompanying documents means
that used electrical and electronic products should not be mixed with general household
waste. For proper disposal, recovery and recycling, please deliver these products to
designated collection points, where they will be accepted free of charge. Alternatively, in
some countries, you may return your products to your local retailer when purchasing an
equivalent new product. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health, which could otherwise be
caused by inappropriate waste handling of this product. Contact your local authority or the nearest collection
point for further details. Improper disposal of this type of waste may result in penalties in accordance with
national regulations.
1. Set the vertical cut degree to 0°.
2. Set the cutting angle to 0°.
3. Set the depth of cut.
1. Set the vertical cut degree to 0°.
2. Set the desired cutting angle.
3. Set the desired depth of cut.
1. Set the desired vertical cut degree.
2. Set the cutting angle to 0°.
3. Set the desired depth of cut.
1. Set the vertical cut degree to 0°.
2. Set the cutting angle to 0°.
3. Place the panel on the cutter
4. Adjust the height of the cut according to the required thickness of
the cut.
5. Make a vertical cut first and then a horizontal cut.
1. Set the vertical cut degree to 0°.
2. Set the cutting angle to 0°.
3. Place the panel on the guide.
4. Turn the panel vertically.
5. Adjust the height of the cut according to the required thickness of
the cut
6. Make a vertical cut and then adjust the panel for the horizontal cut
according to the length of the groove.
MAINTENANCE

ENVIRONMENTAL PROTECTION