Safety Instructions - Strend Pro SDDR-140 Gebrauchsanweisung

SAFETY INSTRUCTIONS

- Do not expose the polystyrene cutter to rain.
- Do not use the polystyrene cutter in a damp or wet environment.
- The workplace must be kept clean and well lit. Clutter and dark spaces are often the cause of accidents.
- Do not use the polystyrene cutter in an environment where there is a risk of explosion, where there are
flammable liquids, gases or dust.
- When using the polystyrene cutter, prevent access by children and other persons. If you are interrupted,
you may lose control over the activity you are doing.
- When not using the polystyrene cutter, store it in a dry, locked place out of the reach of children.
- Do not damage the power cord.
- Do not disconnect the polystyrene cutter from the power source by pulling on the power cord.
- Keep the power cord at a sufficient distance from heat sources.
- CAUTION: Disconnect the tool from the power source before changing the cutting wire. Use only original
cutting wire to avoid the risk of damaging the device.
USE AND ASSEMBLY
- Always disconnect the cutter from the power source before assembling or changing any settings.
Cutting wire assembly:
- Insert both ends of the cutting wire into the spring hook.
Transformer installation:
Cutting procedure:
- After pressing the ON/OFF switch, the cutting wire starts to heat up.
- The ON/OFF switch must be kept pressed for the entire duration of the cut.
- Do not exceed max. time of operation. Otherwise, the power supply may overheat or the cutting wire may
be damaged.