Fitting Instructions
EN
www.herthundbuss.com
51305431
Fitting Instructions
Push the insulating ring provided over the
wires of contacts 1 to 4, position them on the
contact insert and press down until they tan-
gibly engage.
Insert the two remaining wire ends with the
crimped blade receptacles into the outer
chambers of the 3-way receptacle provided
(chambers 1 and 3, chamber 2 is not occu-
pied) and lock in place.
Press the contact insert into the socket hous-
ing again and position the 3-way receptacle
on the microswitch in the socket housing.
Push the rubber seal onto the socket and
screw the socket onto the retaining plate
with screws and nuts.
6
7
51305431
Warning!
a) When assembling the socket, take par-
ticular care that the connection wires
of the 3-pin receptacle (green) are not
trapped and damaged!
b) The seal on the wire outlet from the sock-
et must sit on the insulating sleeve and
not just on the individual wires!
3. Functional check
Connect the earth wire to the battery again
and check all functions.
EN