Safety Instructions, Transport And Maintenance; Unpackaging; Transport - Fm Rx Serie Bedienungsanleitung

• The use of an anti-limescale filter in the water supply inlet is recommended, in case of not using it, some
components of the equipment may be damaged. Any type of damage caused by lime scale or sedi-
ments in the water will be exempt from warranty.
• Failure to comply with any of these safety regulations will exempt FM from any responsibility and will
invalidate the warranty.
Risk of burns
• Read these warnings carefully and follow its indications when the oven is working or not completely
cooled down.
• Only touch the unit control elements and the door handle. Avoid touching any other external element
of the oven as it may reach temperatures over 60ºC.
Risk of fire
• Only use home-use cleaning products and a soft damp cloth to clean the outside coating. Do not use
corrosive or irritating substances.

4. SAFETY INSTRUCTIONS, TRANSPORT AND MAINTENANCE

4.1. Unpackaging

Visible damages: When receiving the material, enter a detailed description of the break in the PDA or
in the delivery note.
General comments such as "damaged packaging" or "damage can be seen", etc. will not be accepted.
Clear photographs showing the damaged good and packaging must be provided.
Hidden damages: When receiving the material and within 24 hours after reception, once the hidden
damage has been checked, photographs showing the damaged good and its corresponding packaging
must be provided. The transport agency label must be clearly visible. Photographs showing the content
only and exclusively will not be accepted.
In either case, transport incidences should be reported to FM Industrial to manage the replacement of
the machine.
If visible damages are detected when receiving the packaged machine, indicate "hits to the oven" at the
time of the delivery, take photos of the damages and transport agency label on the packaging. Please,
contact FM Industrial immediately.
If package is apparently in good conditions, and damages are detected when unpacking, place the ori-
ginal packaging again on the machine, take pictures of the packaging and transport agency label on the
packaging. Next, unpack again and take photos of damages to the machine. Please, contact FM Industrial
immediately

4.2. Transport

Before transporting the unit to its installation site, make sure that:
• Fits through the door
• The floor withstands its weight
Transport should only and exclusively be carried out by mechanical means, such as a pallet jack, and
always on a pallet.
- 12 -