Inhaltsverzeichnis
Werbung
Before the radio is ready for use we need to attach the antenna and battery pack, as well as charge
the battery.
3.1 Installing/ Removing the Antenna
a. Installing the Antenna: Screw the antenna into the connector on the top of the transceiver by
holding the antenna at its base and turning it clockwise until secure.
b. Removing the Antenna: Turn the antenna counter-clockwise to remove it.
3.2 Installing the belt clip
a. At the back of the radio there are two parallel screws mounted above the battery, remove these
and thread them through the holes on the belt clip as you screw them back into the radio body.
b. Removing the Belt Clip: Unscrew counter-clockwise to remove the belt clip.
3.3 Installing the battery pack
Before attaching or removing the battery make sure your radio is turned off by turning the power/volume
knob all the way counter-clockwise.
a. Make sure the battery is aligned in parallel with the radio body with the lower edge of the battery
about 1-2cm below the edge of the radio.
b. Once aligned with the guide-rails, slide the battery upward until you hear a click as the battery locks in
place.
Chapter3. Installation of Accessories
7
Werbung
Inhaltsverzeichnis
